GEO5

Online pomoć

Tree
Settings
Programa:
Jezik:

Linear elastic

The basic parameters of the Linear elastic contact material model are the elastic stiffnesses in the normal and tangential directions Kn and Ks, respectively. They can be imagined as spring stiffnesses along a given interface. A reliable selection of the values of these parameters is not an easy task and is usually problem-dependent. To shed a light on this subject one may relate these stiffnesses to the material parameters of the soil adjacent to the contact. The following relations then apply:

where:

t

-

assumed (fictitious) thickness of contact (interface) layer

G

-

shear modulus of elasticity

E

-

Young’s modulus

In the case of distinct materials (E1, E2, G1, G2) we take the lower value of Ks and Kn.

Although in case of a fully plastic behavior the selection of parameters Ks and Kn is not essential, the values assigned to these parameters are decisive for the success of the solution of a given nonlinear problem. Providing these values too large (above 100000 kN/m3) the iteration process may oscillate. On the other hand, setting the values of Ks and Kn too low (below 10000 kN/m3) lead to nonrealistic deformations of structure.

The default setting in the program is 10000 kN/m3.

Visualization of elastic stiffnesses

Isprobajte GEO5 softver.
Besplatno.