GEO5

Online pomoć

Tree
Settings
Programa:
Jezik:

Liquefaction

The “Liquefaction” frame is used to evaluate the susceptibility of soils to liquefaction during an earthquake, based on a selected CPT or SPT test.

The test to be evaluated is selected in the lower part of the frame, where the earthquake parameters (maximum acceleration and magnitude) and the required safety factor are also entered. It is also possible to ignore a top layer of a specified thickness, limit the maximum depth of assessment, or enter additional parameters. These parameters may vary depending on the method; the analysis method is selected in the “Settings” frame.

Multiple analyses with different settings can be created within a single stage, and it is possible to switch between them.

The left part of the screen shows the plots of the measured quantities, the geological profile, the groundwater table, and the depth intervals in which the calculated safety factor does not reach the required value.

The right part shows the results as a function of depth. The “Visualization” section allows switching between a comparison of the cyclic stress ratio and cyclic resistance ratio (CSR and CRR), the safety factor plot, and the liquefaction potential index (LPI). Detailed results are available using the “In detail” button.

The blue bands in the graphs indicate areas where liquefaction is not evaluated. These are areas outside the applicability conditions of the selected method, for example, those with an excessively high fines content or a high soil behavior type index. They also include areas where the liquefaction assessment is disabled, areas above the groundwater table, and areas outside the specified assessment depth range. Therefore, a blue band does not mean that the soil is safe against liquefaction, but that no assessment was performed in that interval.

Frame “Liquefaction”

Isprobajte GEO5 softver.
Besplatno.